Enterasys D-Series

Resetting the Switch
Enterasys D-Series CLI Reference 2-45
Mode
Switchcommand,read‐only.
Usage
Bydefault,switchtimeoutoccursafter15minutesofuserinactivity, a utomaticallyclosingyour
CLIsession.Usethesetlogoutcommand(page2‐27)tochangethisdefault.
Example
ThisexampleshowshowtoexitaCLIsession:
D2(su)->exit
Resetting the Switch
Purpose
Toresetoneormoreswitches,andtocleartheuser‐definedconfigurationparameters.
Commands
reset
Usethiscommandtoresettheswitchwithoutlosinganyuser‐definedconfigurationsettings.
Syntax
reset
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Examples
Thisexampleshowshowtoresetthesystem:
D2(su)->reset
This command will reset all modules and may disconnect your telnet session.
For information about... Refer to page...
reset 2-45
clear config 2-46