EasyManua.ls Logo

Enterasys D-Series

Enterasys D-Series
540 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Reviewing and Selecting a Boot Firmware Image
Enterasys D-Series CLI Reference 2-31
2. Loadyourpreviousversionofcodeonthedevice,asdescribedin“DownloadingaFirmware
Image”(page 2‐28).
3. Setthisolderversionofcodetobethebootcode,asdescribedin“ReviewingandSelectinga
BootFirmwareImage”(page 2 ‐31).
4. Reloadthesavedconfigurationontothedeviceas
describedin“configure”(page 2‐39).
Reviewing and Selecting a Boot Firmware Image
Purpose
Todisplayandsettheimagefiletheswitchloadsatstartup.TheD2switchallowsyouto
downloadandstoreabackupimage,whichcanbeselectedasthestartupimagebyusingthe
commandsdescribedinthissection.
Commands
show boot system
Usethiscommandtodisplaythefirmwareimagetheswitchloadsatstartup.
Syntax
show boot system
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaytheswitch’sbootfirmwareimage:
D2(su)->show boot system
Current system image to boot: bootfile
For information about... Refer to page...
show boot system 2-31
set boot system 2-32

Table of Contents

Related product manuals