Enterasys D-Series User Manual

Configuring SNMP Users, Groups, and Communities
7-8 SNMP Configuration
Configuring SNMP Users, Groups, and Communities
Purpose
ToreviewandconfigureSNMPusers,groups,andv1andv2communities.Thesearedefinedas
follows:
•User—ApersonregisteredinSNMPv3toaccessSNMPmanagement.
•Group—Acollectionofuserswhosharethesa meSNMPaccessprivileges.
• Community—AnameusedtoauthenticateSNMP v1andv2users.
Commands
show snmp user
UsethiscommandtodisplayinformationaboutSNMPusers.Thesearepeopleregisteredto
accessSNMPmanagement.
Syntax
show snmp user [list] | [user] | [remote remote] [volatile | nonvolatile | read-
only]
Parameters
Defaults
Iflistisnotspecified,detailedSNMPinformationwillbedisplayed.
For information about... Refer to page...
show snmp user 7-8
set snmp user 7-9
clear snmp user 7-10
show snmp group 7-11
set snmp group 7-12
clear snmp group 7-12
show snmp community 7-13
set snmp community 7-14
clear snmp community 7-14
list (Optional)DisplaysalistofregisteredSNMPusernames.
user (Optional)Displaysinformationaboutaspecificuser.
remoteremote (Optional)Displaysinformationaboutusers onaspecificremoteSNMP
engine.
volatile|nonvolatile
|read‐only
(Optional)Displaysuserinformationforaspecifiedstoragetype.

Enterasys D-Series Specifications

General

Brand	Enterasys
Model	D-Series
Category	Switch
Language	English