Enterasys D-Series

show snmp counters
Enterasys D-Series CLI Reference 7-5
show snmp counters
UsethiscommandtodisplaySNMPtrafficcountervalues.
Syntax
show snmp counters
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaySNMPcountervalues
D2(su)->show snmp counters
--- mib2 SNMP group counters:
snmpInPkts = 396601
snmpOutPkts = 396601
snmpInBadVersions = 0
snmpInBadCommunityNames = 0
snmpInBadCommunityUses = 0
snmpInASNParseErrs = 0
snmpInTooBigs = 0
snmpInNoSuchNames = 0
snmpInBadValues = 0
snmpInReadOnlys = 0
snmpInGenErrs = 0
snmpInTotalReqVars = 403661
snmpInTotalSetVars = 534
snmpInGetRequests = 290
snmpInGetNexts = 396279
snmpInSetRequests = 32
snmpInGetResponses = 0
snmpInTraps = 0
snmpOutTooBigs = 0
snmpOutNoSuchNames = 11
snmpOutBadValues = 0
snmpOutGenErrs = 0
snmpOutGetRequests = 0
snmpOutGetNexts = 0
snmpOutSetRequests = 0
snmpOutGetResponses = 396601
snmpOutTraps = 0
snmpSilentDrops = 0
snmpProxyDrops = 0
--- USM Stats counters:
usmStatsUnsupportedSecLevels = 0
usmStatsNotInTimeWindows = 0
usmStatsUnknownUserNames = 0