Enterasys D-Series

clear logging server
14-4 Logging and Network Management
Example
ThiscommandshowshowtoenableaSyslogserverconfigurationforindex1,IPaddress
134.141.89.113,facilitylocal4,severitylevel3onport514:
D2(su)->set logging server 1 ip-addr 134.141.89.113 facility local4 severity 3
port 514 state enable
clear logging server
UsethiscommandtoremoveaserverfromtheSyslogservertable.
Syntax
clear logging server index
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThiscommandshowshowtoremovetheSyslogserverwithindex1fromtheservertable:
D2(su)->clear logging server 1
show logging default
UsethiscommandtodisplaytheSyslogserverdefaultvalues.
Syntax
show logging default
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
index Specifiestheservertableindexnumberfortheservertoberemoved.
Validvaluesare1‐8.