Enterasys D-Series

clear policy profile
11-4 Policy Classification Configuration
Parameters
Defaults
Ifoptionalparametersarenotspecified,nonewillbeapplied.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtocreateapolicyprofile1named“netadmin”withPVIDoverride
enabledforPVID10,and Class‐of‐ServiceoverrideenabledforCoS5:
D2(su)->set policy profile 1 name netadmin pvid-status enable pvid 10 cos-status
enable cos 5
clear policy profile
Usethiscommandtodeleteapolicyprofileentry.
Syntax
clear policy profile profile-index
Parameters
profile‐index Specifiesanindexnumberforthepolicyprofile.Validvaluesare1‐255.
namename (Optional)Specifiesanameforthepolicyprofile.Thisisastringfrom1to
64characters.
pvid‐status
enable|disable
(Optional)EnablesordisablesPVIDoverrideforthisprofile.Ifall
classificationrules
associatedwiththisprofilearemissed,thenthis
parameter,ifspecified,determinesdefaultbehavior.
pvidpvid (Optional)Specifies thePVIDtopackets,ifPVIDoverrideisenabledand
invokedasdefaultbehavior.
cos‐statusenable
|disable
(Optional)EnablesordisablesClassofServiceoverrideforthisprofile.Ifall
classificationrulesassociated
withthisprofilearemissed,thenthis
parameter,ifspecified,determinesdefaultbehavior.
Note: A maximum of 99 rules can be supported per policy profile for policy
profiles that have cos-status enabled..
coscos (Optional)SpecifiesaCoSvaluetoassigntopackets,ifCoSoverrideis
enabledandinvokedasdefaultbehavior.Validvaluesare0to7.
precedence
precedence‐list
(Optional)Assignsaruleprecedencetothisprofile.Lowervalueswillbe
givenhigherprecedence.Foralistofvalues,referto
theshowpolicy
profilecommandoutput.
profile‐index Specifiestheindexnumberoftheprofileentrytobedeleted.Validvalues
are1to255.