Enterasys D-Series

set igmpsnooping adminmode
Enterasys D-Series CLI Reference 13-3
thesystem,referto“setigmpsnoopingadminmode”onpage 13‐3.Forinformationonenabling
IGMPononeormoreports,referto“setigmpsnoopinginterfacemode”onpage 13‐3.
Example
ThisexampleshowshowtodisplayIGMPsnoopinginformation:
D2(su)->show igmpsnooping
Admin Mode..................................... Enable
Group Membership Interval...................... 260
Max Response Time.............................. 100
Multicast Router Present Expiration Time....... 0
Interfaces Enabled for IGMP Snooping........... fe.1.1,fe.1.2,fe.1.3
Multicast Control Frame Count.................. 0
Data Frames Forwarded by the CPU............... 0
set igmpsnooping adminmode
UsethiscommandtoenableordisableIGMPonthesystem.
Syntax
set igmpsnooping adminmode {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
InorderforIGMPsnoopingtobeenabledononeorallports,itmustbegloballyenabledonthe
devicewiththiscommand,andthenenabledonaport(s)usingthesetigmpsnoopinginterface
modecommandasdescribedin“setigmpsnoopinginterfacemode”onpage 13‐3.
Example
ThisexampleshowshowtoenableIGMPonthesystem:
D2(su)->set igmpsnooping adminmode enable
set igmpsnooping interfacemode
UsethiscommandtoenableordisableIGMPononeorallports.
Syntax
set igmpsnooping interfacemode port-string {enable | disable}
enable|disable EnablesordisablesIGMPsnoopingonthesystem.
Note: IGMP snooping cannot be controlled via WebView.