Enterasys D-Series

Creating Diffserv Classes and Matching Conditions
Enterasys D-Series CLI Reference 10-3
Creating Diffserv Classes and Matching Conditions
Purpose
Toreview,create,andconfigureDiffservclassesandmatchingconditions.
Commands
show diffserv info
UsethiscommandtodisplaygeneralDiffservstatusinformation.
Syntax
show diffserv info
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaygeneralDiffservstatusinformation:
D2(rw)->show diffserv info
DiffServ Admin Mode............................ Enable
Class Table Size Current/Max................... 0 / 25
Class Rule Table Size Current/Max.............. 0 / 150
Policy Table Size Current/Max.................. 0 / 12
Policy Instance Table Size Current/Max......... 0 / 120
Policy Attribute Table Size Current/Max........ 0 / 120
Service Table Size Current/Max................. 0 / 48
For information about... Refer to page...
show diffserv info 10-3
show diffserv class 10-4
set diffserv class create 10-4
set diffserv class delete 10-5
set diffserv class match 10-5
set diffserv class rename 10-8