Enterasys D-Series

set dhcp bootp
16-4 DHCP Server Configuration
Example
ThisexampleenablesDHCPserverfunctionality.
D2(rw)->set dhcp enable
set dhcp bootp
UsethiscommandtoenableordisableautomaticaddressallocationforBOOTPclients.By
default,addressallocationforBOOTPclientsisdisabled.RefertoRFC1534,“Interoperation
BetweenDHCPandBOOTP,”formoreinformation.
Syntax
set dhcp bootp {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleenablesaddressallocationforBOOTPclients.
D2(rw)->set dhcp bootp enable
set dhcp conflict logging
Usethiscommandtoenableconflictlogging.Bydefault,conflictloggingisenabled.Usetheclear
dhcpconflictloggingcommandtodisableconflictlogging.
Syntax
set dhcp conflict logging
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
enable|disable EnablesordisablesaddressallocationforBOOTPclients.