Enterasys D-Series

clear port priority
Enterasys D-Series CLI Reference 12-3
Syntax
set port priority port-string priority
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Thesetportprioritycommandwillnotchangethe802.1pprioritytagontaggedtrafficwitha
defaultprioritytag.Thecommandonlyhasaneffectonhowuntaggedtrafficwillbeprioritized
asitpassesinternallythroughthedevice.
Example
Thisexampleshowshowtosetadefaultpriorityof6onfe.1.3.Framesreceivedbythisport
withoutpriorityinformationintheirframeheaderaresettothedefaultsettingof6:
D2(su)->set port priority fe.1.3 6
clear port priority
UsethiscommandtoresetthecurrentCoSportprioritysettingto0.Thiswillcauseallframes
receivedwithoutapriorityvalueinitsheadertobesettopriority0.
Syntax
clear port priority port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
port‐string Specifiestheportforwhichtosetpriority.Foradetaileddescriptionof
possibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”on
page 6‐1.
priority Specifiesavalueof0to7tosettheCoSpriorityfortheport
enteredinthe
port‐string.Priorityvalueof0isthelowestpriority.
port‐string Specifiestheportforwhichtoclearpriority.Foradetaileddescriptionof
possibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”on
page 6‐1.