Enterasys D-Series - Clear Radius; Show Radius Accounting

clear radius
Enterasys D-Series CLI Reference 17-7
Thisexampleshowshowtoforceanymanagement‐access totheswitch(Telnet,web,SSH)to
authenticatethroughaRADIUSserver.Theallparameterattheendofthecommandmeansthat
anyofthedefinedRADIUSserverscanbeusedforthisAuthentication.
D2(rw)->set radius realm management-access all
clear radius
UsethiscommandtoclearRADIUSserversettings.
Syntax
clear radius [retries] | [timeout] | [server {index | all | realm {index | all}}]
Parameters
Mode
Switchcommand,read‐write.
Defaults
None.
Examples
Thisexampleshowshowtoclearallsetting sonallRADIUSservers:
D2(su)->clear radius server all
ThisexampleshowshowtoresettheRADI UStimeouttothedefaultvalueof20seconds:
D2(su)->clear radius timeout
show radius accounting
UsethiscommandtodisplaytheRADIUSaccountingconfiguration.Thistransmitsaccounting
informationbetweenanetworkaccessserverandasharedaccountingserver.
Syntax
show radius accounting [server] | [counter ip-address] | [retries] | [timeout]
retries ResetsthemaximumnumberofattemptsausercancontacttheRADIUS
serverbeforetimingoutto3.
timeout Resetsthemaximumamountoftimetoestablishcontactwith theRADIUS
serverbeforetimingoutto20seconds.
server Deletesserversettings.
index|all Forusewiththeserverparameter
tocleartheserverconfigurationforall
serversoraspecificRADIUSserverasdefinedbyanindex.
realm ResetstherealmsettingforallserversoraspecificRADIUSserveras
definedbyanindex.