Enterasys D-Series

set ssl
Enterasys D-Series CLI Reference 2-49
set ssl
UsethiscommandtoenableordisabletheuseofWebViewoverSSLport443.Bydefault,SSLis
disabledontheswitch.Thiscommandcanalsobeusedtoreinitializethehostkeythatisusedfor
encryption.
Syntax
set ssl {enabled | disabled | reinitialize | hostkey reinitialize}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoenableSSL:
D2(rw)->set ssl enabled
enabled|disabled EnableordisabletheabilitytouseWebViewoverSSL.
reinitialize StopsandthenrestartstheSSLprocess.
hostkeyreinitialize StopsSSL,regeneratesnewkeys,andthenrestartsSSL.