Enterasys D-Series

show cos state
11-20 Policy Classification Configuration
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoenableClassofService:
D2(rw)->set cos state enable
show cos state
UsethiscommandtodisplaytheClassofServiceenablestate.
Syntax
show cos state
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtoshowtheClassofServiceenablestate:
D2(rw)->show cos state
Class-of-Service application is enabled
clear cos state
UsethiscommandtosetCoSstatebacktoitsdefaultsettingofdisabled.
Syntax
clear cos state
Parameters
None.
enable|disable EnablesordisablesClassofServiceontheswitch.Defaultstateis
disabled.