Enterasys D-Series - Clear Spantree Portpri

clear spantree portpri
8-36 Spanning Tree Configuration
Parameters
Defaults
Ifsidisnotspecified,portprioritywillbesetforSpanningTree0.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosetthepriorityoffe.1.3to240onSID1
D2(su)->set spantree portpri fe.1.3 240 sid 1
clear spantree portpri
UsethiscommandtoresetthebridgepriorityofaSpanningTreeporttoadefaultvalueof128.
Syntax
clear spantree portpri port-string [sid sid]
Parameters
Defaults
Ifsidisnotspecified,portprioritywillbesetforSpanningTree0.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoresetthepriorityoffe.1.3to128onSID1
D2(su)->clear spantree portpri fe.1.3 sid 1
port‐string Specifiestheport(s)forwhichtosetSpanningTreeportpriority.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 6‐1.
priority SpecifiesanumberthatrepresentsthepriorityofalinkinaSpanningTree
bridge.Valid
valuesarefrom0to240(inincrementsof16)with0
indicatinghighpriority.
sidsid (Optional)SetsportpriorityforaspecificSpanningTreeidentifier.Valid
valuesare0‐4094.Ifnotspecified,SID0isassumed.
port‐string Specifiestheport(s)forwhichtosetSpanningTreeportpriority.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 6‐1.
sidsid (Optional)ResetstheportpriorityforaspecificSpanningTreeidentifier.
Validvaluesare0‐
4094.Ifnotspecified,SID0willbeassumed.