Enterasys D-Series

set cos port-config
Enterasys D-Series CLI Reference 11-23
Parameters
Defaults
Ifnotspecified,allCoSentrieswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtoshowallCoSsettings:
D2(su)->show cos settings
CoS Index Priority ToS IRL
--------- ---------- ------- -----
0 0 * *
1 1 * *
2 2 * *
3 3 * *
4 4 * *
5 5 * *
6 6 * *
7 7 * *
set cos port-config
Usethiscommandtocreateaportgroupforinboundratelimitingandaddorremove portsfrom
thegroup.
Syntax
set cos port-config irl group-type-index [name name] [ports port-list] [append] |
[clear]
Parameters
cos‐list (Optional)SpecifiesaClassofServiceentrytodisplay.
irl Specifiesthatthisisan inboundratelimiting(IRL)portgroup.
group‐type‐index Specifiesaninboundratelimitingportgroup/typeindex.Validentriesare
intheformofgroup#.port‐type.
Validvaluesforgroup#canrangefrom0to7. Validvaluesforport‐type
canrangefrom0to
1,althoughonlyporttype0iscurrentlysupported.
Forexample,portgroup3wouldbespecifiedas3.0.
namename (Optional)Userdefinednameforthegroup.
portsport‐list (Optional)Portsassignedtothegroup.Allportsmustbeofthesameport
type(FastEthernet,GigabitEthernet).
append
(Optional)Append(add)theportstotheportsthatarealreadyinthe
group.
clear (Optional)Clearthegivenportsfromthoseassignedtothe group.