show logging server
14-2 Logging and Network Management
show logging server
UsethiscommandtodisplaytheSyslogconfigurationforaparticularserver.
Syntax
show logging server [index]
Parameters
Defaults
Ifindexisnotspecified,allSyslogserverinformationwillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaySyslogserverconfigurationinformation:
D2(ro)->show logging server
IP Address Facility Severity Description Port Status
-------------------------------------------------------------------------
1 132.140.82.111 local4 warning(5) default 514 enabled
2 132.140.90.84 local4 warning(5) default 514 enabled
Table 14‐32providesanexplanationofthecommandoutput.
clear logging application 14-8
show logging local 14-9
set logging local 14-9
clear logging local 14-10
show logging buffer 14-10
For information about... Refer to page...
index (Optional)DisplaysSysloginformationpertainingtoaspecificserver
tableentry. Validvaluesare1‐8.
Table 14-32 show logging server Output Details
Output Field What It Displays...
IP Address Syslog server’s IP address. For details on setting this using the set logging server
command, refer to “set logging server” on page 14-3.
Facility Syslog facility that will be encoded in messages sent to this server. Valid values are:
local0 to local7.
Severity Severity level at which the server is logging messages.
Description Text string description of this facility/server.
Port UDP port the client uses to send to the server.
Status Whether or not this Syslog configuration is currently enabled or disabled.
To Next Page
Loading...
Need help?
General