Enterasys D-Series - Set Igmpsnooping Groupmembershipinterval

set igmpsnooping groupmembershipinterval
13-4 IGMP Configuration
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
InorderforIGMPsnoopingtobeenabledononeorallports,itmustbegloballyenabledonthe
deviceusingthesetigmpsnoopingadminmodecommandasdescribedin“setigmpsnooping
adminmode”onpage 13‐3,andthenenabledonaport(s)usingthiscommand.
Example
ThisexampleshowshowtoenableIGMPonportge.1.10:
D2(su)->set igmpsnooping interfacemode ge.1.10 enable
set igmpsnooping groupmembershipinterval
UsethiscommandtoconfiguretheIGMPgroupmembershipintervaltimeforthesystem.
Syntax
set igmpsnooping groupmembershipinterval time
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
TheIGMPgroupmembershipintervaltimesetsthefrequencyofhost‐queryframetransmissions
andmustbegreaterthantheIGMPmaximumresponsetimeasdescribedin“setigmpsnooping
maxresponse”onpage 13‐5.
port‐string SpecifiesoneormoreportsonwhichtoenableordisableIGMP.
enable|disable Enables
ordisablesIGMP.
time SpecifiestheIGMPgroupmembershipinterval.Validvaluesare2‐3600
seconds.
Thisvalueworkstogetherwiththesetigmpsnoopingmaxresponsetime
commandtoremoveportsfromanIGMPgroupandmustbegreaterthan
themaxresponsetimevalue.