Enterasys D-Series - Clear Spantree Portadmin; Show Spantree Portadmin

clear spantree portadmin
8-34 Spanning Tree Configuration
Example
ThisexampleshowshowtodisableSpanningTreeonfe.1.5:
D2(rw)->set spantree portadmin fe.1.5 disable
clear spantree portadmin
UsethiscommandtoresetthedefaultSpanningTreeadminstatustoenableononeormoreports.
Syntax
clear spantree portadmin port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoresetthedefaultSpanningTreeadminstatetoenableonfe.1.12:
D2(rw)->clear spantree portadmin fe.1.12
show spantree portadmin
UsethiscommandtodisplaythestatusoftheSpanningTreealgorithmononeormoreports.
Syntax
show spantree portadmin [port port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,statuswillbedisplayedforallports.
Mode
Switchcommand,read‐only.
port‐string Resetsthedefaultadminstatusonspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage 6‐1.
portport‐string (Optional)Displaysstatusforspecificport(s).Foradetaileddescriptionof
possibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”
onpage 6‐1.