Enterasys D-Series

set mac agetime
Enterasys D-Series CLI Reference 14-21
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaytheMACtimeoutperiod:
D2(su)->show mac agetime
Aging time: 300 seconds
set mac agetime
UseThiscommandtosetthetimeoutperiodforaginglearnedMACentries.
Syntax
set mac agetime time
Parameters
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtosettheMACtimeoutperiod:
D2(su)->set mac agetime 250
clear mac agetime
UsethiscommandtoresetthetimeoutperiodforaginglearnedMACentriestothedefaultvalue
of300seconds.
Syntax
clear mac agetime
Parameters
None.
Defaults
None.
time SpecifiesthetimeoutperiodinsecondsforaginglearnedMAC
addresses.Validvaluesare10to1,000,000seconds.Defaultvalueis300
seconds.