Enterasys D-Series - Set Port Speed; Show Port Duplex

set port speed
Enterasys D-Series CLI Reference 6-11
set port speed
Usethiscommandtosetthedefaultspeedofoneormoreports.Thissettingonlytakeseffecton
portsthathaveauto‐negotiationdisabled.
Syntax
set port speed port-string {10 | 100 | 1000}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosetfe.3.3toaportspeedof10 Mbps:
D2(su)->set port speed fe.3.3 10
show port duplex
Usethiscommandtodisplaythedefaultduplexsetting(halforfull)foroneormoreports.
Syntax
show port duplex [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,defaultduplexsettingsforallportswillbedisplayed.
Mode
Switchcommand,read‐only.
port‐string Specifiestheport(s)forwhichtoaspeedvaluewillbeset.Fora
detaileddescriptionofpossibleport‐stringvalues,refer to“Port
StringSyntaxUsedintheCLI”onpage6‐1.
10|100|1000 Specifiestheportspeed.Validvaluesare:
10 Mbps,100 Mbps,or
1000 Mbps.
port‐string (Optional)Displaysdefaultduplexsetting(s)forspecificport(s).
Foradetaileddescriptionofpossibleport‐stringvalues,referto
“PortStringSyntaxUsedintheCLI”onpage6‐1.