Enterasys D-Series

set sntp poll-interval
14-30 Logging and Network Management
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoremovetheserveratIPaddress10.21.1.100 fromtheSNTPserverlist:
D2(su)->clear sntp server 10.21.1.100
set sntp poll-interval
Usethiscommandtosetthepollinterval betweenSNTPunicastrequests.
Syntax
set sntp poll-interval interval
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosettheSNTPpollintervalto30seconds:
D2(su)->set sntp poll-interval 30
clear sntp poll-interval
UsethiscommandtoclearthepollintervalbetweenunicastSNTPrequests.
Syntax
clear sntp poll-interval
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
interval Specifiesthepollintervalinseconds.Validvaluesare16to16284.