Enterasys D-Series

show spantree spanguard
Enterasys D-Series CLI Reference 8-25
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoresettheprotocolstatemigrationmachineonport20:
D2(su)->set spantree protomigration ge.1.20
show spantree spanguard
UsethiscommandtodisplaythestatusoftheSpanningTreeSpanGuardfunction.
Syntax
show spantree spanguard
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaytheSpanGuardfunctionstatus:
D2(su)->show spantree spanguard
Spanguard is disabled
set spantree spanguard
UsethiscommandtoenableordisabletheSpanningTreeSpanGuardfunction.
Syntax
set spantree spanguard {enable | disable}
Parameters
Defaults
None.
enable|disable EnablesordisablestheSpanGuardfunction.