Enterasys D-Series - Show Cos Reference

show cos reference
Enterasys D-Series CLI Reference 11-29
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
TheCoSreferencetablemapstheuser‐definedIRLreferencesfoundintheCoSsettingstable(see
“setcossetting s”onpage 11‐21)toratelimiterscreatedintheportresourcetable(see“setcos
port‐resource”onpage 11‐26).TheCoSreferencetableindexescanbethoughtof
asvirtualrate
limiters.Thetableaccountsforthemaximumnumberofratelimiterssupportedbythedevice.
Thevirtuallimitersthenmaptothephysicalratelimiters.TheCoSIRLReferenceTableisnot
configuredbydefault.
TheCoSIRLreferencetableuses100indexesorvirtualratelimiters,and
mapseachvirtuallimiter
toaphysicallimiterorresource.AnIRLreferencetableexistsforeachportgroupconfigured,and
isindexedsimilarlytoportresources,asportgroup#,port‐type,reference.IRLreferencesarenot
populatedwithlimiters(resources),butcanbeconfiguredbytheuser.TheIRL
referencetablecan
bedisplayedusingtheshowcosreferencecommand.
Example
IntheCoSIRLreferencemappingtableforportgroups1.0and2.0,createareferencefortheIRL
resourcenumber1createdforeachgroup.Thereferencenumber1isused.
D2(su)->set cos reference irl 1.0 1 rate-limit 1
D2(su)->set cos reference irl 2.0 1 rate-limit 1
show cos reference
UsethiscommandtoshowtheClassofServiceinboundratelimitingreferenceconfiguration.
Syntax
show cos reference [irl [group-type-index]]
irl SpecifiesthatanIRLreferenceisbeingconfigured.
group‐type‐index Specifiesaninboundratelimitingportgroup/typeindex.Validentriesare
intheformofgroup#.port‐type.
Validvaluesforgroup#canrangefrom0to7. Validvaluesforport‐type
canrangefrom0to1,althoughonly
porttype0iscurrentlysupported.
Forexample,portgroup3wouldbespecifiedas3.0.
reference IRLreferencenumberassociatedwiththisentry.
rate‐limitirl‐index Ratelimiter(IRLresourceindex)tobindthisreferenceto.Validvalues
rangefrom0to99.