Enterasys D-Series

show newaddrtrap
Enterasys D-Series CLI Reference 7-29
Commands
show newaddrtrap
Usethiscommandtodisplaythe globalandport‐specificstatusoftheSNMPnewMACaddresses
trapfunction.
Syntax
show newaddrtrap [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,thestatusofthenewMACaddressestrapfunctionwillbedisplayed
forallports.
Mode
Switchcommand,read‐only.
Usage
Bydefault,thisfunctionisdisabledgloballyandperport.
Example
ThisexampledisplaysthestatusforGigabitEthernetports1through5inslot1.
D2(ro)->show newaddrtrap ge.1.1-5
New Address Traps Globally disabled
Port Enable State
--------- ------------
For information about... Refer to page...
show newaddrtrap 7-29
set newaddrtrap 7-30
show snmp notify 7-30
set snmp notify 7-31
clear snmp notify 7-32
show snmp notifyfilter 7-33
set snmp notifyfilter 7-34
clear snmp notifyfilter 7-34
show snmp notifyprofile 7-35
set snmp notifyprofile 7-36
clear snmp notifyprofile 7-36
port‐string (Optional)DisplaysthestatusofthenewMACaddressestrapfunction
onspecificports.