Enterasys D-Series

set radius accounting
17-8 Security Configuration
Parameters
Mode
Switchcommand,read‐only.
Defaults
Ifnoparametersarespecified,allRADIUSaccountingconfigurationinformationwillbe
displayed.
Example
ThisexampleshowshowtodisplayRADIUSaccountingconfigurationinformation.Inthiscase,
RADIUSaccountingisnotcurrentlyenabledandglobaldefaultsett ingshavenotbeenchanged.
Oneserverhasbeenconfigured.
FordetailsonenablingandconfiguringRADIUSaccounting,referto“setradiusaccounting”on
page 17‐8:
D2(ro)->show radius accounting
RADIUS accounting status: Disabled
RADIUS Acct Server IP Address Acct-Port Retries Timeout Status
------------------ ---------- --------- ------- ------- ------
1 172.16.2.10 1856 3 20 Disabled
set radius accounting
UsethiscommandtoconfigureRADIUSaccounting.
Syntax
set radius accounting {[enable | disable] [retries retries] [timeout timeout]
[server ip_address port [server-secret]
Parameters
server (Optional)DisplaysoneorallRADIUSaccountingserverconfigurations.
counterip‐address (Optional)DisplayscountersforaRADIUSaccountingserver.
retries (Optional)Displaysthemaximumnumberofattemptstocontactthe
RADIUSaccountingserverbeforetimingout.
timeout (Optional)Displaysthemaximumamou ntoftimebeforetimingout.
enable|disable EnablesordisablestheRADIUSaccountingclient.
retriesretries SetsthemaximumnumberofattemptstocontactaspecifiedRADIUS
accountingserverbeforetimingout.Validretryvaluesare0‐10.