Enterasys D-Series

show system hardware
2-14 Basic Configuration
show system hardware
Usethiscommandtodisplaythesystem’shardwareconfiguration.
Syntax
show system hardware
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaythesystem’shardwareconfiguration.Pleasenotethatthe
informationyouseedisplayedmaydifferfromthisexample.
D2(su)->show system hardware
SLOT 1 HARDWARE INFORMATION
---------------------------
Model: D2G124-12
Serial Number: 777777777777
Vendor ID: 0xbc00
Base MAC Address: 00:11:88:B1:76:C0
Hardware Version: BCM56514 REV 1
FirmWare Version: 01.00.00.0052
Boot Code Version: 01.00.42
show system utilization
Usethiscommandtodisplaydetailedinformationabouttheprocessorrunningontheswitch,or
theoverallmemoryusageoftheFlashandSDRAMstoragedevicesontheunit,ortheprocesses
runningontheswitch.Onlythememoryusageinthemasterunitofastackisshown.
Syntax
show system utilization {cpu | storage | process}
Parameters
Defaults
None.
cpu Displayinformationabouttheprocessorrunningontheswitch.
storage Displayinformationaboutthe overallmemoryusageontheswitch.
process Displayinformationaboutthe processesrunningontheswitch.