EasyManua.ls Logo

Enterasys D-Series

Enterasys D-Series
540 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
set telnet
Enterasys D-Series CLI Reference 2-33
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayTelnetstatus:
D2(su)->show telnet
Telnet inbound is currently: ENABLED
Telnet outbound is currently: ENABLED
set telnet
UsethiscommandtoenableordisableTelnetontheswitch.
Syntax
set telnet {enable | disable} [inbound | outbound | all]
Parameters
Defaults
Ifnotspecified,bothinboundandoutboundTelnetservicewillbeenabled.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtodisableinboundandoutboundTelnetservices:
D2(su)->set telnet disable all
Disconnect all telnet sessions and disable now (y/n)? [n]: y
All telnet sessions have been terminated, telnet is now disabled.
telnet
UsethiscommandtostartaTelnetconnectiontoaremotehost.TheD‐Seriesswitchallowsatotal
offourinboundand/oroutboundTelnetsessiontorunsimultaneously.
Syntax
telnet host [port]
enable|disable EnablesordisablesTelnetservices .
inbound|
outbound|all
(Optional)Specifiesinboundservice(theabilitytoTelnettothisswitch),
outboundservice(theabilitytoTelnettootherdevices),orall(both
inboundandoutbound).

Table of Contents

Related product manuals