Enterasys D-Series User Manual

set multiauth session-timeout
Enterasys D-Series CLI Reference 17-43
Example
Thisexampledisplaysthesessiontimeoutvaluesforallauthenticationmethods.
D2(su)->show multiauth session-timeout
Authentication type Timeout (sec)
------------------- -------------
dot1x 0
pwa 0
mac 0
set multiauth session-timeout
Usethiscommandtosetthemaximumnumberofsecondsanauthenticatedsessionmaylast
beforeterminationofthesession.
Syntax
set multiauth session-timeout [dot1x | mac | pwa] timeout
Parameters
Defaults
Ifnoauthenticationmethodisspecified,thesessiontimeoutvalueissetforallauthentication 
methods.
Mode
Switchmode,read‐write.
Usage
Avalueofzeromaybesupersededbyasessiontimeoutvalueprovidedbytheauthenticating
server.Forexample,ifasessionisauthenticatedbyaRADIUSserver,thatservermayencodea
Session‐TimeoutAttributeinitsauthentication response.
Example
ThisexamplesetsthesessiontimeoutvaluefortheIEEE802.1Xauthenticationmethodto300
seconds.
D2(su)->set multiauth session-timeout dot1x 300
dot1x (Optional)SpecifiestheIEEE802.1Xport‐basednetworkaccesscontrol
authenticationmethodforwhichtosetthesessiontimeoutvalue.
mac (Optional)SpecifiestheEnterasysMACauthenticationmethodfor 
whichtosetthesessiontimeoutvalue.
pwa (Optional)SpecifiestheEnterasysPortWebAuthenticationmethodfor
whichtosetthesessiontimeout
value.
timeout Specifiesthetimeoutvalueinseconds.Thevaluecanrangefrom0to
65535.Avalueof0meansthatnosessiontimeoutwillbeappliedunless
asessiontimeoutvalueisprovidedbytheauthenticatingserver.

Enterasys D-Series Specifications

General

Brand	Enterasys
Model	D-Series
Category	Switch
Language	English