Enterasys D-Series - Clear Summertime; Set Prompt

clear summertime
2-20 Basic Configuration
Defaults
Ifanoffsetisnotspecified,nonewillbeapplied.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowsetdaylightsavingstimetorecurstartingonthefirstSundayofAprilat
2a.m.andendingthelastSundayofOctoberat2a.m.withanoffsettimeofonehour:
D2(su)->set summertime recurring first Sunday April 02:00 last Sunday October
02:00 60
clear summertime
Usethiscommandtoclearthedaylightsavingstimeconfiguration.
Syntax
clear summertime
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoclearthedaylightsavingstimeconfiguration:
D2(su)->clear summertime
set prompt
Usethiscommandtomodifythecommandprompt.
Syntax
set prompt prompt_string
Parameters
prompt_string Specifiesatextstringforthecommandprompt.
Note: A prompt string containing a space in the text must be enclosed
in quotes as shown in the example below.