Enterasys D-Series

clear ip address
Enterasys D-Series CLI Reference 2-11
Mode
Switchcommand,read‐write.
Usage
Paramtersmustbeenteredintheordershown(hostIP,thenmask,thengateway)forthe
commandtobeaccepted.
Example
ThisexampleshowshowtosetthesystemIPaddressto10.1.10.1withamaskof255.255.128.0:
D2(su)->set ip address 10.1.10.1 mask 255.255.128.0
clear ip address
UsethiscommandtoclearthesystemIPaddress.
Syntax
clear ip address
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoclearthesystemIPaddress:
D2(rw)->clear ip address
show ip protocol
UsethiscommandtodisplaythemethodusedtoacquireanetworkIPaddressforswitch
management.
Syntax
show ip protocol
Parameters
None.
Defaults
None.