Enterasys D-Series

set lacp asyspri
Enterasys D-Series CLI Reference 6-41
set lacp asyspri
UsethiscommandtosettheLACPsystempriority.
Syntax
set lacp asyspri value
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
LACPusesthisvaluetodetermineaggregationprecedence.Iftherearetwopartnerdevices
competingforthesameaggregator,LACPcomparestheLAGIDsforeachgroupingofports.The
LAGwiththelowerLAGIDisgivenprecedenceandwillbeallowedtousetheaggregator.
Example
ThisexampleshowshowtosettheLACPsystempriorityto1000:
D2(su)->set lacp asyspri 1000
set lacp aadminkey
Usethiscommandtosettheadministrativelyassignedkeyforoneormoreaggregatorports.
Syntax
set lacp aadminkey port-string value
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
asyspri SetsthesystemprioritytobeusedincreatingaLAG(LinkAggregation
Group)ID.Validvaluesare0 to65535.
value Specifiesasystempriorityvalue.Validvaluesare0to65535,with
precedencegiventolowervalues.
port‐string SpecifiestheLAGport(s)onwhichtoassignanadminkey.
value Specifiesanadminkeyvaluetoset.Validvaluesare0to65535.The
defaultadminkeyvalueis32768.