Enterasys D-Series

show logging local
Enterasys D-Series CLI Reference 14-9
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoresettheloggi ngseveritylevelto6for SNMP.
D2(rw)->clear logging application SNMP
show logging local
Usethiscommandtodisplaythestateofmessageloggingtotheconsoleandapersistentfile.
Syntax
show logging local
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaythestateofmessagelogging.Inthiscase,loggingtothe
consoleisenabledandloggingtoapersistentfileisdisabled.
D2(su)->show logging local
Syslog Console Logging enabled
Syslog File Logging disabled
set logging local
Usethiscommandtoconfigurelogmessagestotheconsoleandapersistentfile.
Syntax
set logging local console {enable | disable} file {enable | disable}
mnemonic Resetstheseveritylevelforaspecificapplicationto6. Validmnemonic
valuesandtheircorrespondingapplicati onsare listedinTable 14‐34on
page 14‐8.
all Resetstheseveritylevelforallapplicationsto6.