Enterasys D-Series

clear spantree lp
Enterasys D-Series CLI Reference 8-43
Defaults
Ifnoport‐stringisspecified,statusisdisplayedforallports.
IfnoSIDisspecified,SID0isassumed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayLoopProtectstatusonfe.2.3:
D2(su)->show spantree lp port fe.2.3
LoopProtect is disabled on port fe.2.3 , SI
clear spantree lp
UsethiscommandtoreturntheLoopProtectstatusperportandoptionally,perSID,toitsdefault
stateofdisabled.
Syntax
clear spantree lp port-string [sid sid]
Parameters
Defaults
IfnoSIDisspecified,SID0isassumed.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoreturntheLoopProtect stat eonfe.2.3todisabled:
D2(rw)->clear spantree lp port fe.2.3
show spantree lplock
UsethiscommandtodisplaytheLoopProtectlockstatusperportand/orperSID.Aportcan
becomelockedifaconfigurednumberofLoopProtectev entsoccurduringtheconfigured
windowoftime.Seethesetspantreelpthresholdandsetspantreelpwindowcommands.Oncea
portisforcedinto
blocking(locked),itremainslockeduntilmanuallyunlockedwiththeclear
spantreelplockcommand.
Syntax
show spantree lplock [port port-string] [sid sid]
port‐string Specifiesport(s)forwhichtocleartheLoopProtectfeaturestatus.
sidsid (Optional)SpecifiesthespecificSpanningTree(s)forwhichtoclearthe
LoopProtectfeaturestatus.Validvaluesare0‐4094.Ifnotspecified ,
SID0isassumed.