Enterasys D-Series

show spantree tctrapsuppress
Enterasys D-Series CLI Reference 8-23
Example
ThisexampleshowshowtoresetthebackuprootfunctiontodisabledonSID2:
D2(rw)->clear spantree backuproot 2
show spantree tctrapsuppress
UsethiscommandtodisplaythestatusoftopologychangetrapsuppressiononRapidSpanning
Treeedgeports.
Syntax
show spantree tctrapsuppress
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaythestatusoftopologychangetrapsuppression:
D2(rw)->show spantree tctrapsuppress
Topology change Trap Suppression is set to enabled
set spantree tctrapsuppress
UsethiscommandtodisableorenabletopologychangetrapsuppressiononRapidSpanningTree
edgeports.
Syntax
set spantree tctrapsuppress {disable | enable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
disable|ena ble Disablesorenablestopologychangetrapsuppression.