Enterasys D-Series - Set Length; Show Logout

set length
2-26 Basic Configuration
set length
UsethiscommandtosetthenumberoflinestheCLIwilldisplay.Thiscommandispersistent
(writtentoNV‐RAM).
Syntax
set length screenlength
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosettheterminallengthto50:
D2(su)->set length 50
show logout
Usethiscommandtodisplaythetime(inseconds)anidleconsoleorTelnetCLIsessionwill
remainconnectedbeforetimingout.
Syntax
show logout
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaytheCLIlogoutsetting:
D2(su)->show logout
Logout currently set to: 10 minutes.
screenlength SetsthenumberoflinesintheCLIdisplay.Validvaluesare0,which
disablesthescrollingscreenfeaturedescribedin“DisplayingScrolling
Screens”onpage1‐8,andfrom5to512.