Enterasys D-Series - Clear Lacp Static

clear lacp static
Enterasys D-Series CLI Reference 6-43
Defaults
Ifnotspecified,akeywillbeassignedaccordingtothespecifiedaggregator. Forexampleakeyof4
wouldbeassignedtolag.0.4.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoaddportfe.1.6totheLAGofaggregatorport6:
D2(su)->set lacp static lag.0.6 fe.1.6
clear lacp static
UsethiscommandtoremovespecificportsfromaLinkAggregation Group.
Syntax
clear lacp static lagportstring port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoremovefe.1.6fromtheLAGofaggregatorport6:
D2(su)->clear lacp static lag.0.6 fe.1.6
key (Optional)Specif iesthenewmemberportandLAGportaggregator
adminkeyvalue.Onlyportswithmatchingkeysareallowedto
aggregate.Validvaluesare0‐65535.
Note: This key value must be unique. If ports other than the desired
underlying physical ports share the same admin key value, aggregation
will fail or undesired aggregations will form.
port‐string Specifiesthememberport(s)toaddtotheLAG.Foradetaileddescription
ofpossibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”
onpage6‐1.
lagportstring SpecifiestheLAGaggregatorportfromwhichportswillberemoved.
port‐string Specifiestheport(s)toremovefromtheLAG.Foradetaileddescriptionof
possibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”
onpage6‐1.