Enterasys D-Series - Chapter 4: Configuring System Power and PoE; show inlinepower

Enterasys D-Series CLI Reference 4-1
4
Configuring System Power and PoE
ThecommandsinthischapterallowyoutoreviewandsetsystempowerandPoEparameters,
includingthepoweravailabletothesystem,theusagethresholdforeachmodule,whetherornot
SNMPtrapmessageswillbesentwhenpowerstatuschanges,andper‐portPoEsettings.
Commands
show inlinepower
Usethiscommandtodisplaysystempower properties.
Syntax
show inlinepower
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Important Notice
Some commands in this section apply only to PoE-equipped D-Series devices. Consult the Installation Guide
shipped with your product to determine if it is PoE-equipped.
For information about... Refer to page...
show inlinepower 4-1
set inlinepower threshold 4-2
set inlinepower trap 4-2
show port inlinepower 4-3
set port inlinepower 4-3