To Next Page

To Previous Page

show radius

17-4 Security Configuration

show radius

UsethiscommandtodisplaythecurrentRADIUSclient/serverconfiguration.

Syntax

show radius [status | retries | timeout | server [index | all]]

Parameters

Defaults

Ifnoparametersarespecified,allRADIUSconfigurationinformationwillbedisplayed.

Mode

Switchcommand,read‐only.

Example

ThisexampleshowshowtodisplayRADIUSconfigurationinformation:

D2(rw)->show radius

RADIUS status: Enabled

RADIUS retries: 3

RADIUS timeout: 20 seconds

RADIUS Server IP Address Auth-Port Realm-Type

-------------- ---------- --------- -----------------

10 172.16.20.10 1812 management-access

Table 17‐42providesanexplanationofthecommandoutput.

set radius accounting 17-8

clear radius accounting 17-9

For information about... Refer to page...

status (Optional)DisplaystheRADIUSserver’senablestatus.

retries (Optional)DisplaysthenumberofretryattemptsbeforetheRADIUSserver

timesout.

timeout (Optional)Displaysthemaximumamountoftime(inseconds)toestablish

contactwiththeRADIUSserverbeforeretryattempts begin.

server(Optional)DisplaysRADIUSserverconfigurationinformation.

index|all Foruse

withtheserverparametertoshowserverconfigurationforall

serversoraspecificRADIUSserverasdefinedbyanindex.

Table 17-42 show radius Output Details

Output Field What It Displays...

RADIUS status Whether RADIUS is enabled or disabled.

RADIUS retries Number of retry attempts before the RADIUS server times out. The default value of 3

can be reset using the set radius command as described in “set radius” on

page 17-5.

Enterasys D-Series User Manual

Questions and Answers: