Enterasys D-Series

show spantree lpthreshold
Enterasys D-Series CLI Reference 8-47
Defaults
None.Thedefaulteventthresholdis3.
Mode
Switchcommand,read‐write.
Usage
TheLoopProtecteventthresholdisaglobalintegervariablethatprovidesprotectioninthecaseof
intermittentfailures.Thedefaultvalueis3.Iftheeventcounterreachesthethresholdwithina
givenperiod(theeventwindow),thentheport,forthegivenSID,becomeslocked(thatis,held
indefinitelyin
theblockingstate).Ifthethresholdis0,theportsareneverlocked.
Example
ThisexampleshowshowtosettheLoopProtectthresholdvalueto4:
D2(rw)->set spantree lpthreshold 4
show spantree lpthreshold
UsethiscommandtodisplaythecurrentvalueoftheLoopProtecteventthreshold.
Syntax
show spantree lpthreshold
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaythecurrentLoopProtectthresholdvalue:
D2(rw)->show spantree lpthreshold
The Loop Protect event threshold value is 4
clear spantree lpthreshold
UsethiscommandtoreturntheLoopProtecteventthresholdtoitsdefaultvalueof3.
Syntax
clear spantree lpthreshold
Parameters
None.