Enterasys D-Series

show macauthentication session
Enterasys D-Series CLI Reference 17-23
show macauthentication session
UsethiscommandtodisplaytheactiveMACauthenticatedsessions.
Syntax
show macauthentication session
Parameters
None.
Defaults
Ifport‐stringisnotspecified,MACsessioninformationwillbedisplayedforallMAC
authenticationports.
Mode
Switchcommand,read‐only.
Usage
ChangingtheReauthPeriodwiththesetmacauthenticationreauthperiodcommanddoesnot
affectcurrentsessions.Newsessionsdisplaythecorrectperiod.
Example
ThisexampleshowshowtodisplayMACsessioninformation:
D2(su)->show macauthentication session
Port MAC Address Duration Reauth Period Reauthentications
----- ----------------- ---------- ------------- -----------------
ge.1.2 00:60:97:b5:4c:07 0,00:52:31 3600 disabled
Table 17‐45providesanexplanationofthecommandoutput.
Reauth Period Reauthentication period for this port. Default value of 30 can be changed using the
set macauthentication reauthperiod command (page 17-29).
Auth Allowed Number of concurrent authentications supported on this port. Default is 1 and cannot
be reset.
Auth Allocated Maximum number of MAC authentications permitted on this port. Default is 1 and
cannot be reset
Reauthentications Whether or not reauthentication is enabled or disabled on this port. Set using the set
macauthentication reauthentication command (page 17-28).
Table 17-44 show macauthentication Output Details (Continued)
Output Field What It Displays...
Table 17-45 show macauthentication session Output Details
Output Field What It Displays...
Port Port designation. For a detailed description of possible port-string values, refer to
“Port String Syntax Used in the CLI” on page 6-1.
MAC Address MAC address associated with the session.