Enterasys D-Series

set rmon channel
15-18 RMON Configuration
Example
ThisexampleshowshowtodisplayRMONchannelinformationforfe.2.12:
D2(rw)->show rmon channel fe.2.12
Port fe.2.12 Channel index= 628 EntryStatus= valid
----------------------------------------------------------
Control off AcceptType matched
OnEventIndex 0 OffEventIndex 0
EventIndex 0 Status ready
Matches 4498
Description Thu Dec 16 12:57:32 EST 2004
Owner NetSight smith
set rmon channel
UsethiscommandtoconfigureanRMONchannelentry.
Syntax
set rmon channel index port-string [ accept { matched | failed}] [control { on | off}]
[description description] [owner owner]
Parameters
Defaults
Ifanactionisnotspecified,packetswillbeacceptedonfiltermatches.
Ifnotspecified,controlwillbesettooff.
Ifadescriptionisnotspecified,nonewillbeapplied.
Ifownerisnotspecified,itwillbesettomonitor.
Mode
Switchcommand,read‐write.
index Specifiesanindexnumberforthisentry.Anentrywillautomaticallybe
createdifanunusedindexnumberischosen.Maximumnumberof
entriesis2.Maximumvalueis65535.
port‐string Specifiestheportonwhichtrafficwillbemonitored.
acceptmatched|
failed
(Optional)Specifiesthe
actionofthefiltersonthischannelas:
• matched‐Packetswillbeacceptedonfiltermatches
• failed‐Packetswillbeacceptediftheyfailamatch
controlon|off (Optional)Enablesordisablescontroloftheflowofdatathroughthe
channel.
description
description
(Optional)Specifiesadescriptionforthischannel.
ownerowner (Optional)Specifiesthenameoftheentitythatconfiguredthisentry.