Enterasys D-Series

Packet Capture Commands
15-22 RMON Configuration
Packet Capture Commands
Notethatpacketcapturefilterissamplingonlyanddoesnotguaranteereceiptofback‐to‐back
packets.
Purpose
TodisplayRMONcaptureentries,configure,enable,ordisablecaptureentries,andclearcapture
entries.
Commands
show rmon capture
UsethiscommandtodisplayRMONcaptureentriesandassociatedbuffercontrolentries.
Syntax
show rmon capture [index [nodata]]
Parameters
Defaults
Ifnooptionsarespecified,allbuffercontrolentriesandassociatedcapturedpacketswillbe
displayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayRMONcaptureentriesandassociatedbufferentries:
D2(rw)->show rmon capture
Buf.control= 28062 Channel= 38283 EntryStatus= valid
----------------------------------------------------------
FullStatus avail FullAction lock
Captured packets 251 Capture slice 1518
Download size 100 Download offset 0
Max Octet Requested 50000 Max Octet Granted 50000
Start time 1 days 0 hours 51 minutes 15 seconds
For information about... Refer to page...
show rmon capture 15-22
set rmon capture 15-23
clear rmon capture 15-24
index (Optional)Displaysthespecifiedbuffercontrolentryandallcaptured
packetsassociatedwiththatentry.
nodata (Optional)Displaysonlythebuffercontrolentryspecifiedbyindex.