Enterasys D-Series

clear multiauth session-timeout
17-44 Security Configuration
clear multiauth session-timeout
Usethiscommandtoresetthemaximumnumberofconsecutivesecondsanauthenticatedsession
maylastbeforeterminationofthesessiontoitsdefaultvalueof0.
Syntax
clear multiauth session-timeout [dot1x | mac | pwa]
Parameters
Defaults
Ifnoauthenticationmethodisspecified,thesessiontimeoutvalueisresettoitsdefaultvalueof0
forallauthenticationmethods.
Mode
Switchmode,read‐write.
Example
ThisexampleresetsthesessiontimeoutvaluefortheIEEE802.1Xauthenticationmethodto0
seconds.
D2(su)->clear multiauth session-timeout dot1x
dot1x (Optional)SpecifiestheIEEE802.1Xport‐basednetworkaccesscontrol
authenticationmethodforwhichtoresetthetimeoutvaluetoits
default.
mac (Optional)SpecifiestheEnterasysMACauthenticationmethodfor 
whichtoresetthetimeoutvaluetoitsdefault.
pwa (Optional)SpecifiestheEnterasysPortWebAuthenticationmethodfor
whichto
resetthetimeoutvaluetoitsdefault.