Enterasys D-Series

clear spantree spanguardtimeout
8-28 Spanning Tree Configuration
clear spantree spanguardtimeout
UsethiscommandtoresettheSpanningTreeSpanGuardtimeouttothedefaultvalueof300
seconds.
Syntax
clear spantree spanguardtimeout
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoresettheSpanGuardtimeoutto300seconds:
D2(rw)->clear spantree spanguardtimeout
show spantree spanguardlock
UsethiscommandtodisplaytheSpanGuardlockstatusofoneormoreports.
Syntax
show spantree spanguardlock [port-string]
Parameters
Defaults
Ifnoportstringisspecified,theSpanGuardlockstatusforallportsisdisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaytheSpanGuardlockstatus forge.1.1:
D2(su)->show spantree spanguardlock ge.1.1
Port ge.1.1 is Unlocked
port‐string (Optional)Specifiestheport(s)forwhichtoshowSpanGuardlockstatus.
Foradetaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 6‐1.