Enterasys D-Series

set diffserv class delete
Enterasys D-Series CLI Reference 10-5
Example
ThisexampleshowshowtocreateaDiffservclasscalled“admin”: 
D2(rw)->set diffserv class create all admin
set diffserv class delete
UsethiscommandtodeleteaDiffservclassandremoveanymatchassignedtotheclass.
Syntax
set diffserv class delete classname
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Youcannotusethiscommandtodeleteaclassthathasbeenassignedtoa policy.Beforedeletinga
classwithanassignedpolicyandserviceport(s),youmustfirst:
•Removetheserviceport(s)assignedtothepolicyusingthesetdiffservserviceremove
command(page 10‐16),then
•Removethespecified
classusingthesetdiffservpolicyclassremovecommand(page 10‐11).
Example
ThisexampleshowshowtodeletetheDiffserv“admin”class:
D2(rw)->set diffserv class delete admin
set diffserv class match
UsethiscommandtomatchaDiffservclasstoaserviceconditionbasedonlayer2,3,and 4packet
parameters.
set diffserv class match {[every classname] [dstmac | scrmac classname macaddr
macmask] [dstip | srcip classname ipaddr ipmask] [dstl4port | srcl4port{keyword
classname keyword | number classname portnumber}] [ipdscp classname dscpval]
[ipprecedence classname precedencenumber] [iptos classname tosbits tosmask]
[protocol {keyword classname protocol-name | number classname protocol-number}]
[refclass {add | remove}{classname refclassname}] [vlan classname vlanid]}
classname Specifiestheclassnametobedeleted.