Enterasys D-Series

clear spantree fwddelay
Enterasys D-Series CLI Reference 8-21
clear spantree fwddelay
UsethiscommandtoresettheSpanningTreeforwarddelaytothedefaultsettingof15seconds.
Syntax
clear spantree fwddelay
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtogloballyresetthebridgeforwarddelay:
D2(su)->clear spantree fwddelay
show spantree backuproot
UsethiscommandtodisplaythebackuprootstatusforanMSTinstance.
Syntax
show spantree backuproot [sid]
Parameters
Defaults
IfaSIDisnotspecified,thenstatuswillbeshownforSpanningTreeinstance0.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaythestatusofthebackuprootfunctiononSID0:
D2(rw)->show spantree backuproot
Backup root is set to disable on sid 0
sid (Optional)DisplaybackuprootstatusforaspecificSpanningTree
identifier.Validvaluesare0 ‐4094.Ifnotspecified,SID0isassumed.