Enterasys D-Series

clear spantree adminedge
8-40 Spanning Tree Configuration
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoresetfe.1.11asanon‐edgeport:
D2(su)->clear spantree adminedge fe.1.11
port‐string Specifiesport(s)onwhichtoresetedgeportstatus.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage 6‐1.