Enterasys D-Series

set garp timer
Enterasys D-Series CLI Reference 9-25
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Thesettingofthesetimersiscriticalandshouldonlybechangedby personnelfamiliarwiththe
802.1Qstandardsdocumentation,whichisnotsuppliedwiththisdevice.
Examples
ThisexampleshowshowtosettheGARPjointimervalueto100centisecondsforallports:
D2(su)->set garp timer join 100 *.*.*
Thisexampleshowshowtosettheleavetimervalueto300centisecondsforallports:
D2(su)->set garp timer leave 300 *.*.*
Thisexampleshowshowtosettheleavealltimervalueto20000centisecondsforallports:
D2(su)->set garp timer leaveall 20000 *.*.*
leavealltimer‐
value
SetstheGARPleavealltimerincentiseconds(Referto802.1Qstandard.)
port‐string Specifiestheport(s)onwhichtoconfigureGARPtimersettings.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 6‐1.