GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
3-176 Section 3-4 - Preparing for Installation
PRELIMINARY
c.) The current path information is displayed below the Patient List as well as number of studies,
cumulative size and amount of space available on the drive. By default, the destination path
Other Folder radio button is enabled.
d.) Select the required exam or exams, as shown in Figure 3-205.
e.) (Use Ctrl +click to select more than one study; Shift + click to select a group of studies)
f.) The currently-selected exams are now highlighted in the list and, as shown in Figure 3-205,
the cumulative size of the 3 studies is displayed below.
g.) The three study management buttons are now as follows:
h.) Delete Selected Patients - enabled
i.) Copy Selected Patients and Move Selected Patients - remain disabled until at least one Study
has been selected and the Destination Path has been specified (providing the destination is
NOT read-only media [such as, CD/DVD-ROM]). Only when both these tasks have been
performed will these two buttons become enabled.
j.) To copy or move the selected exams, first click the Browse button and select the required
destination folder, then click the Copy Selected Patients or Move Selected Patients button
as appropriate.
k.) (If necessary, click the Review Destination folder button to review the destination folder Patient
List).
l.) During the copy or move operation, the relevant message and progress bar is displayed:
Figure 3-205 Exams Selected
To Next Page
Loading...
