GE
P
ART NUMBER FN091065, REVISION 2 VS5 N AND VS6 N SERVICE MANUAL
7-80 Section 7-4 - Performing Front End (FE) Diagnostics
PRELIMINARY
7-4-6 Probe Select Board Diagnostic Tests (cont’d)
NOTE: The ACW BPF Test has four test reports (BPF0, BPF1, BPF2, and BPF3) which are listed in
the Reports window on the right. By default, the BPF0 report is displayed in the Reports window
below (Figure 7-49 "View Test Log - ACW BPF Test - BPF0" on page 7-80).
7) When finished reviewing the first report, trackball to the Exit button and press Set to close the View
Report window.
8) Select the second report (BPF1); the report is highlighted in the Reports list, and the corresponding
results are shown in the Report window below, as shown in Figure 7-50 "View Test Log - ACW BPF
Test - BPF1" on page 7-81.
Figure 7-49 View Test Log - ACW BPF Test - BPF0
To Next Page
Loading...
